Welcome back to Make it Monday (sorry for missing last week with the lack of internet connection )
     
              This weeks home made home tutorial
                   Recovering a Lampshade
                                                       comes from
                                     http://craftylittlechick.blogspot.co.uk/

                                          so lets get started ......

 Materials Needed:
-Lampshade 
-Fabric of your Choice 
-No Sew Fabric Glue
-Heat N Bond Hem Tape
-Iron
-Scissors
-Clothespins or Paper clips
-Newspaper



Step 1:  Using a sheet of the newspaper, trace one of the sides of the shade to create a pattern.  Depending on how many sides your shade has (most have 4 or 6), use this paper pattern to cut out the correct number you will need from your fabric.

Now measure the length (top to bottom of shade) of one of the sides.  Cut appropriate number of strips you will need to cover the edges of your lamp.  I usually cut my strips about 1 1/4 inches wide, but you can make them wider if you so desire. 

You will also need a strip of fabric for the top and bottom circumference of the shade. 



Step 2:  Take each strip of fabric and lay it out flat.  Now cut a piece of the Heat N Bond Hem tape that is the same length as your strip of fabric.  Lay the hem tape down the center of the strip and iron in both sides so that they meet.  As you iron, the hem tape will glue the fabric together to form a finished edging for the lamp.  Repeat this step until all of your strips have been ironed together. 




Step 3:  Now take your fabric glue and apply around all 4 edges of one of the sides of the lamp.  Carefully place one of your pre-cut fabric pieces over the face of the shade and smooth to make sure there are no wrinkles.   Repeat for all sides of the lamp.  (*Please note that I do not spread glue over the entire side of the shade.  Just glueing the edges will hold the fabric secure, making it easy to take apart if you ever wish to recover the shade in the future).




Step 4:  Now take the fabric strips you just ironed and glue them to each corner of the shade.  This strip of fabric should cover over the seams where your fabric is glued to give it a finished edge.  





Step 5:  Almost finished!  All you have to do now is glue the strips of fabric around the top and bottom of the lamp to completely finish off all of the raw edges.  I usually will fasten paper clips to the edges while the glue dries to ensure that it is securely fastened to the shade. 



Step 6: Now enjoy using your new lampshade! :) 
                                                   craftylittlechick.blogspot.com/
 
Top